BU4052BCFV-E2-ROHM-Price, Stock & Datasheet

BU4052BCFV-E2 Overview

This electronic part is conveniently packaged in 16-LSSOP (0.173, 4.40mm Width), making it easy to ship abroad. This high-reliability packaging method uses advanced packaging methods Tape & Reel (TR). A switch device like this is mounted in Surface Mount. 4:1 is the ratio of multiplexer to demultiplexer circuits. An extended operating temperature of -40°C~85°C TA degrees Celsius. In total, there have been 16 terminations. A 4 channel electronic part produces high-quality output. A 5V voltage supply should turn on and run the electronic component. An injection of 16 pins is performed into the body of the electrical component. Unlike digital switches, these are based on SP4T switching circuits. 2 circuits are used in this analogue multiplexer. Try searching for BU4052 variants of the analog switch ic. Analog switches have 160Ohm internal resistance. To find out what the 16 pins do, please refer to the datasheets. It is a typical Multiplexer or Switches analog multiplexer. Users should never supply a voltage higher than 18V to a switch device. Analog switch ics with Single supply type are cost-effective. There should be 3V voltage fed to the electrical part below 3V. It would be sufficient to run this analogue multiplexer with 15μA current. A voltage of 3V~18V is required for this switch device, which drains from a single voltage source. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 9V. The voltage should be at least 1.5V if you are using dual power supplies. This product is integrated with an analog integrated circuit (IC) of type DIFFERENTIAL MULTIPLEXER. In order to operate the 8 inputs, there are several steps to follow. In 20MHz-bandwidths, data can be transferred.