ADG451BN-ADI-Price, Stock & Datasheet

ADG451BN Overview

The electrical component comes in 16-DIP (0.300, 7.62mm) packaging, which makes it convenient to ship overseas. To ensure high reliability, a new packaging method Tube is used. In Through Hole, you'll find this switch device. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. Operating temperature around -40°C~85°C TA extended. In total, 16 terminations have occurred. A electrical component with 4 channels is capable of high-quality output. When the electronic component is given a voltage of 5V, it should be turned on and run. Into the electrical component body are injected 16 pins. On the other hand, analog switches can be constructed using SPST - NC switching circuits. Look for analog switch ic variants by searching with ADG451. A 5Ohm internal resistance characterizes this multiplexer. The datasheets for the 16 pins explain the functions. The analog multiplexer shown here is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 12V. A analog switch ic that has a cost-effective Dual, Single supply type. It is recommended to use 5V as the lowest voltage for the electrical part. A voltage higher than 500nA may cause damage to the switch multiplexer. For this switch, a dual supply voltage is feasible, but it must not exceed 15VFor dual power supplies, a voltage of at least 5V should be attached. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer. You shouldn't miss the additional features of the electrical component, such as: ALSO OPERATE WITH 12V SINGLE SUPPLY. There is 4mOhm Drain to Source resistance on this electronic part.